In order to extend the life of sanding machine to avoid the sand mill in the course of the work will be abnormal, to ensure the normal operation of the machine in daily life should pay attention to maintenance and repair. In this case,

Sander in addition to the daily maintenance requirements, but also regularly stop grinding, the hollow shaft, the main bearing, cylinder and reducer as well as large and small gear and other important parts to do a serious inspection. And then develop the relevant repair plan. In this case,

1, it is necessary to pay attention to the sand mill all the lubricants in the sand mill can only run up to a month to release all of the machine and add oil thoroughly cleaned, and a new replacement of the new oil. In this case,

2, sanding machine in operation, the main bearing lubricating oil temperature can not be higher than 58 ℃. The transmission bearing and reducer temperature rise can not be higher than 58 ℃, the maximum does not exceed 70 ℃. The transmission of the large and small gears is very smooth and does not produce abnormal noise. But also to adjust the gap in a timely manner. In this case,

4, the next is the main bearing inspection, the main bearing when there is serious wear and tear that should be replaced. When the grate plate of the lattice grinder is worn, it should be replaced immediately if it can not be welded. In this case,

Our main sanding machine, we in order to meet the needs of different user conditions, to provide users with a more rational and more applicable products to meet user requirements under the premise of saving as much as possible for users of equipment investment!